face flange
英 [feɪs flændʒ]
美 [feɪs flændʒ]
n. 平面法兰
双语例句
- The urethane liner extends over the flange face to serve as the valve's flange gasket.
这种氨基甲酸乙酯延展覆盖到法兰表面，起到阀门法兰衬垫的作用。 - Seat Face: Negates need for flange gaskets.
阀座：需使阀兰垫圈。 - When used with a raised face flange, there will be a gap between the faces on the outer flange diameters.
如果使用凸面法兰，则在外法兰直径表面之间将会有间隙。 - The gasket face of the flange should squarely contact the face of the mating flange.
法兰垫圈面应该与配套法兰面均匀接触。 - Full face gaskets extending to the flange face edge as given in American Standard Non-Metal Gaskets for Pipe Flanges ANSI B16.21 are required.
根据用于管道法兰的美国非金属衬垫标准ANSIB16.21，需要能够延伸至法兰面边缘的全面衬垫。 - Nozzle projections are from the vessel centerline to the gasket face of flange.
喷嘴设计是从容器中心线到法兰密封面。 - Welds to be performed on site shall be kept at a maximum distance back from the face of the orifice flange.
需现场进行的焊接应保持距孔板法兰后面最大距离。 - The Field Repair of the Seal Face of the Manhole Flange in the Urea Converter
尿素合成塔人孔法兰密封面的现场修复 - Disposal for Mid-diameter Deviation Exceeded Standard on Trapezoidal Groove Face Flange
梯形槽面法兰中径偏差超标的处理方法 - Temperature Sensors were introduced on the exterior face of the flange plate to measure the temperature of the radiated area so as to make necessary adjustments timely of current, volt, focus, etc.
为防止因此导致扫描盒前端法兰盘局部温升过高，在法兰的外侧安装温度传感器以实时监测受照点的温度，从而及时调整系统的电流、电压、聚焦等有关参数。 - The scheme was based upon F-P interference, the F-P cavity was composed with one polished surface of bimetal and one polished end face of optical fiber inserted in a common flange optical fiber connector.
该方案采用F-P腔干涉机理，利用常见的法兰盘光纤连接器，以热双金属片抛光表面和插入连接器的尾纤端面构成F-P腔。 - The Field Repair of the Seal Face of the Manhole Flange in the Stripper
E101汽提塔人孔法兰密封面的现场修复 - Apply the finite element method ( FEM) to simulate the drawing process of rectangle case based on pyramidal face blank-holder which in the region of curve edge of blank flange, and contrast its equivalent strain 、 major strain 、 depth of drawing etc.
用有限元数值模拟的方法，模拟法兰曲边区域采用锥面压料面时，矩形盒的拉深成形过程，并且与平面压料时法兰在等效应变、主应变分布、拉深深度等方面进行了对比分析。